PREPARING FOR FIELD LEVEL TESTING: Remove Flip Assembly
54 68P80401P05
7.14 Remove Flip Assembly
7.14.1 Procedure to remove flip assembly:
Tools: Black stick. NO metallic tools!
NOTE: i580 flip components include a Flex Connector ribbon which can be easily torn or
damaged if not handled properly. Handle the Flex Ribbon with care especially when
working it through the front housing slot.
1. Remove the keypad and main board from the front housing. Make sure the flip is in the open
position.
2. Remove the three T-4 screws securing the frame-flip center hinge. Flip the unit over and lift the
flip-center hinge straight up to remove.
3. Locate the slight gap between the right knuckle and flip assembly. Align the flat tip of the black
stick with the gap.
Figure 7-8.
2
3
To Next Page
Loading...
