Motorola INTELLIGENCE EVERYWHERE I860 - Chapter 3 Displays, Messages, and Alerts; Power-Up Sequence

68P80400P73-A 3-1
CHAPTER 3
DISPLAYS, MESSAGES, AND ALERTS
To conduct basic troubleshooting and maintenance of the i860 unit, you must become familiar
with the display screens, errors, messages, and alert tones associated with the unit.
3.1 Power-Up Sequence
Extend the antenna for optimum power and press
p
momentarily to turn on the unit and begin the
power-up sequence. The power-up sequence initiates a series of displays on the unit. As shown
below, each display reflects a stage of the sequence. If the last display shows the idle screen, the
power up was successful; if the last display shows No Service, the unit is out of range or there is a
hardware or software problem.
If the vibrate function is enabled for incoming phone calls, voice mail, or message mail, the power-
up sequence includes a 500 ms. vibrate cycle. Depending upon your service provider, the power-up
sequence screens may differ from those shown.
Figure 3-1. Power-Up Sequence Displays
1. Power-Up Display
3. Connecting Display
-OR-
5. Phone Ready Display
(Idle Screen)
4. No Service Display
Please Wait
d
o
Connecting...
No service
d
Enter SIM PIN
Code:
Delete
d
o
1
2. No SIM Display
Ready
d
o
1
Contcs
Mesg
S
10/12 3:57pm
Powering On
Insert SIM
Cancel
d
o
1
Note: Text that appears on Idle
screen depends on carrier.
Note: SIM PIN code can be
canceled. (See programming menu
section.)
Note: After Powering On the
carrier logo will appear and
next the T9 text input logo. Some
carriers may not include T9 or other
Motorola features in the power up
display