Motorola JT 1000 - Page 40

To temporarily delete a nuisance
channel from the scan list, press SB1
when locked on to that channel. The
channel is put back into the scan list
upon turning scan off and re-entering
into scan.
For OSS radio programming informa-
tion, refer to your operating instructions
manual.
Programming Features
The radio display and keypad provide fast
access to three programming features:
• Multi-selectable PL/DPL/CSQ,
• Squelch Level Adjust, and
• Power Level Selection
For programming information on these
three features, refer to your operating
instructions manual.
Quik-Call ll™ Decode Signalling
Quik-Call ll is a per-radio feature enabled
on a per-channel basis and offered as
individual call, group call, and dual call.
To activate Quik-Call, turn the radio on
and place the ABC switch in the A
position (if so programmed) or rotate the
channel selector to the channel
programmed for Quik-Call ll.The display
will show QC. When a page is received,
the green LED flashes and an alert tone
is emitted.The radio resets to the
signalling muting state automatically (if
programmed for auto reset) or when the
monitor button is pressed.
Touch-Code™ DTMF
A DTMF programmed radio can transmit
and receive phone calls through the
public telephone system.
• Calling with Auto Access: Press the
orange button, listen for the dial
tone, and dial using the keypad.
Press the orange button to hang up.
• Calling with Manual Dial: Press the
orange button to enter the phone
mode. Enter any required access
code using the keypad. Enter the
deaccess code to hang up.
Repeater Talkaround
Transmit DIRECT (portable-to-portable),
bypassing the repeater, or transmit in
the REPEAT mode, through a repeater
for increased range. This feature can be
programmed to the ABC switch (DIRECT
on one position and REPEAT on another
position), or to selected channels.
Smart PTT
With this feature enabled, your radio:
• will not transmit on a busy channel,
or
• will not transmit on a busy channel
with PL/DPL squelch code other than
your own.
Pressing the PTT on a busy channel
causes a continuous alert tone until the
PTT is released, (no transmission
occurs).
PLACE
POSTAGE
HERE
From:
Radio Products Group
Attn: Bindery 8000 W. SUNRISE BOULEVARD FT. LAUDERDALE, FLORIDA 33322
68P81078C45-A
*6881078C45*