To monitor and adjust volume,
press side button 3 (SB3) and
adjust the On/Off Volume
control to a comfortable
listening level.
To receive, turn the radio on,
select the desired channel, and
monitor for activity. Selecting a
blank channel causes an error
tone.
To transmit, turn the radio on,
select the desired channel, and
monitor for activity. When clear,
press the PTT (LED lights red) and
speak into microphone area.
Release PTT to receive.
Channel Scan™
Three types of channel scan are offered:
• Auto Scan (AS)
• Preprogrammed Scan (PS)
• Operator Selectable Scan (OSS)
To turn scan on, turn the radio on and:
• AS- rotate the channel selector to the
preprogrammed scan channel.
• PS- and OSS- place the proper switch
in the scan position.
In AS and PS radios, the priority
channel is preprogrammed and is not
user programmable. In OSS radios, the
priority channel is user programmable
and is the channel selected by the
position of the channel selector knob.
dispatch display numeric display
OPERATING INSTRUCTIONS QUESTIONNAIRE
We believe that reports from users provide valuable information for
producing quality operating instructions. Your comments and answers to
the following questions will aid us in preparing manuals that contain
accurate and complete information of maximum benefit to you.
In reference to Manual No.
JT 1000
TM
Portable Radios
68P81078C45-A
Controls and
Features
Operating
Procedures
Clear
illustrations
text
illustrations
Alert Tone Explanations
Battery Information
Options
Model Information
Accessories
General Care Information
Other (specify)
Confusing
Too Detailed
Too Brief
Adequate
Complete
Incomplete
Incorrect
Not Covered
in This Manual
text
2. For illustrating procedures, do you prefer:
photographs line drawings no preference
3. How would you rate the overall organization of this manual?
excellent very good good fair poor
4a. If this manual has a "quick reference card," do you use it?
yes no
4b. If yes, how useful is it to you?
extremely very somewhat not very
5. How do you rate this manual overall?
excellent very good good fair poor
6. Comments/Recommendations for improving operating instructions.
1. Please check all the appropriate boxes:
SB1
(SB)
SB2
SB3
PTT
JT 1000™ Portable Radios
Quick Reference Card
Basic Operation
Install the antenna, battery, and
belt clip.
Turn the radio on (or off) using
the On/Off Volume control.
Selective-Channel Display
After the radio is turned on and following
a power-up sequence, a preprogrammed
selective-channel display is shown one of
two ways:
or
13
15
1
3
5
7
9
11
Flashing = low battery.
Receive function, on = carrier
squelch; off = coded squelch.
Flashing = in program mode; not
flashing = keypad is disabled.
Flashes when a Quik-Call II page is
received.
On = scanning; off = not scanning.
Flashing dot = priority scan.
On = direct communication, radio to
radio; off = communication through
a repeater.
LCD and Status Annunciators
To Next Page
Loading...
