Operation
Dial-Up Connection to the Radio
3-10MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)
deskset to a remote radio, for both voice (audio) and data communication. The maximum
number of digits allowed in a dialing sequence is fourteen.
To enter the Configuration and Test menu:
1. Press and hold the Shift button and then press the Sel button. When you enter the
Configuration and Test program, the first line of the LCD display will read the “Button
Test” and the second line will read “Press Menu”.
2. At any time you can press the Mode Up or Down buttons to move up or down the
main or sub menu options. Options (1 - 7) on the main menu are tests you can run.
Options (8 -17) on the main menu are deskset parameters that you can configure.
3. Press the Menu/Home button to enter and exit the sub menu.
Note: To exit the sub menu without connecting or disconnecting, press the Mode Up or
Mode Down buttons until you are in the ‘Voice’ or ‘Data’ sub menu options, before press-
ing the Menu/Home button to exit the sub menu.
To ‘dial up’ and connect through modems to a radio remotely:
1. Press and hold the Shift button and then press the Sel button. When you enter the
Configuration and Test program, the first line of the LCD display will read the “Buttons
& LEDs Test” and the second line will read “Press Menu”.
2. At any time you can press the Mode Up or Down buttons to move up or down the
menu options. Options (1 - 7) on the menu are tests you can run. Options (8 -17) on
the menu are deskset parameters that you can configure.
3. After you enter the program, press the Mode Down button until you get to the desired
parameter (number 15 ”Dial Up” on the main menu). Look at the LCD display to find
the parameter. The first line will state “Dial Up” and the second line will state ”Press
Menu”.
4. Press the Menu/Home button to enter the sub menu. The first line will state “Dial Up:”
and the second line will state ”Voice”.
5. Press the Mode Up or Down button to navigate to the desired parameter value. You
have four choices: Voice, Data, Connect and Disconnect.
6. Enter the site-specific telephone number for the voice (audio) link with the keypad
number keys (0 - 9). The numbers you enter will be displayed in the bottom left hand
corner of the LCD display. At any time you can press the Shift button to move back
and erase one character at a time.
7. Press the Mode Down button once to access the “Data” option in the sub menu. The
first line of the LCD display will state “Dial Up” and the second line will state ”Data”. At
any time you can press the Mode Up button to go back and change or correct the pre-
vious entry.
8. Enter the site-specific telephone number for the voice (audio) link with the keypad
number keys (0 - 9). The numbers you enter will be displayed in the bottom left hand
WARNING: Although the deskset can be connected to four types of radios, it is con-
figured to one type at a time. The deskset will operate properly only when connected
to the radio type for which it has been configured. Therefore, if you want to dial up to a
different radio type, you must have a technician re-configure the deskset for the new
radio type.
To Next Page
Loading...
Need help?
General