8
English
5. Insert a battery into the charger’s rear pocket by:
a. aligning the groove on each side of the battery with the corresponding raised rail on each side of the
charger pocket.
b. sliding the battery into the charger pocket, ensuring complete contact between the charger and
battery contacts.
6. When the battery is properly seated in the pocket, the charger LED will light in accordance with Table 5
on page 10.
Note:
• Charge new batteries overnight to ensure full charge.
• The Amplifier Charger is not designed to accommodate the alkaline battery tray.
68012010008_b.book Page 8 Tuesday, May 6, 2014 2:07 PM
To Next Page
Loading...
