2.2.2
Installing the SIM Card
IMPORTANT: The following procedure must be performed only in non-hazardous environment.
Prerequisites:
Your radio is equipped with a SIM/microSD card slot.
Prepare Phillips torque bit and 2.7+0.2/-0.0 in-lbs torque screwdriver.
Procedure:
1 Remove the battery.
2 Unscrew the M2 countersunk Phillips screw that secures the SIM card door to the chassis.
3
Remove the SIM card door (1).
IMPORTANT:
Ensure that the screw O-ring (3) remains attached to the screw (2) all the time. If any of
these elements appear damaged, replace them.
4
Slide the SIM card into the SIM card door. Pay attention to the correct position of the notched
corner.
6866588D06–RB
Chapter 2: Getting Started
20 Send Feedback
To Next Page
Loading...
