4.9.2.1
Activating Talkgroup Scanning
When and where to use: If you want to monitor any TMO Group Call in the defined talkgroup list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Scan → Scanning.
3 Select Select List and then a list name.
Your radio displays list name selected.
4 Select Scanning → On.
Your radio is scanning on the predefined scan list.
4.9.2.2
Setting Talkgroups in the Active Scan List
When and where to use: If you want to edit talkgroups in the active scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Scan → Active List.
NOTICE: If Scanning is Off is displayed, go to Group Setup → Scan → Scanning
→ On to enable scanning.
3 Select
View and highlight the required talkgroup.
4 Press Menu.
5 Select one of the following:
• Delete — Erases this group from the active scan list.
• Priority and select new priority to Low, Medium or High.
4.9.2.3
Setting Scan Lists
When and where to use: If you want to set up any scan list.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup → Scan → Scan Lists.
3 Highlight required scan list and press Menu to see additional settings:
• Capacity — Displays the number of assigned and unassigned talkgroups for the scan list.
• Clear — Deletes all the talkgroup assigned to that scan list.
• Add Group
— Adds a talkgroup to the scan list. Select one talkgroup from your talkgroup
folders and assign appropriate priority.
• Edit — Changes the priority of the required talkgroup or deletes it.
6866588D06–RB
Chapter 4: Main Menu
90 Send Feedback
To Next Page
Loading...
