4.6.4
Devices
This menu item lists all devices paired with your radio and allows you to perform the following
operations:
• Connect a device.
• View and change device details.
• Disconnect a device.
• Delete a device.
4.6.4.1
Connecting or Disconnecting Devices
Prerequisites: Only pre-approved sensor devices can be used. The service provider is responsible for
configuring the radio to work with specific devices. See Add Bluetooth Devices on page 140.
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth → Devices.
3 Highlight the required device and press Menu/OK. Select Connect/Disconnect.
NOTICE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle (power off and
power on of the radio), reconnect the device manually.
4.6.4.2
Managing Devices
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth → Devices.
3 Highlight the required device and press the Menu key.
• Name – shows the name of the device (up to 32 characters long). The name is editable only
if it has not been pre-set by the service provider.
•
Type – displays the device type. This menu item cannot be configured.
•
Access – defines how the radio behaves during a reconnection attempt after losing
connection to this device:
•
Automatic – the radio connects with the device automatically.
NOTICE:
On some headsets, you may have to press the "Call" button to trigger
reconnection.
•
Ask – the radio asks you for confirmation before connecting with the device.
•
Manual – the radio connects with the device manually.
•
Never – the radio never connects with the device.
MN002033A01–AC (en-US)
Chapter 4: Main Menu
Send Feedback 89
To Next Page
Loading...
Need help?
General
