PROGRAMMING THE
RADIO
40
English
Note: The programming-mode annunciator, K,
blinks while program mode is active.
• In the edit mode, the , key functions as
a backspace key. Pressing it erases the
previous digit, and the cursor moves to the
left. When the last digit on the display has
been erased, additional presses of this key
or the / key will cause you to leave the
edit mode without making any changes.
• When the maximum of 16 digits in an entry
for the telephone list is reached, the cursor
disappears. If you try to add any more
digits, you will hear an invalid (bad)
keypress alert tone.
Programming the Call List
This feature lets you use the radio’s keypad to
change the radio ID numbers assigned to the call list
used by the trunked Private Conversation™ and
Call Alert™ features. Similarly, in Conventional
Mode, you may change the Call List used by Stat-
Alert Selective Call and Call Alert.
To change the call list radio ID numbers
9 Use any of the alphanumeric keys to make the
changes. The blinking cursor indicates the
position of the next number to be added. If you
require a pause in the phone dialing sequence
(to allow for a delay), you can do so by first
pressing the “*” key, followed by pressing the
“#” key. The display will show a “P” for pause.
10 When you have finished changing the
telephone number, press the select key again.
The change is saved in the radio’s memory.
11 You are returned to Step
5. The display will again
alternate between the
member’s name and
telephone number. You
can now change
additional numbers.
Alternates between
and
12 When you have finished making changes,
press to exit program mode.
13 The radio returns to the
home display.
POLICE DEPT
5556445
PLANT POLICE
1 Press / until PROG is
displayed.
2 Press l (the softkey
below PROG).
3 Press l (the softkey
below CALL). The
display shows the first
programmable member
of the call list.
DIR
SCAN
PROG
SCAN
PHON
CALL
SK TAN
To Next Page
Loading...
