TELEPHONE
OPERATION
43
English
Sending the Telephone Number
Sending the Telephone Number Using the Keypad
Sending the Telephone Number Using a Number on
the Telephone List
4 If you connect successfully, you will hear a dial
tone.
5 The display shows the
last number dialed.
6a The number can now be entered from the
keypad, using any of the numeric (0 – 9) keys,
and the “*” and “#” keys. The cursor blinks to
indicate the location of the next digit to be
entered. A pause can be entered in the
telephone number by first pressing the “*” key,
then the “#” key (Buffered dial only – the
pause is shown on the display as a “P”).
6b If your radio is programmed for “live dial,”
each digit is sent out as its key is pressed.
—or—
If your radio is programmed for “buffered dial,”
each digit is temporarily stored as you enter
them. After entering the number, press the
PTT switch to send out the number.
6c The telephone number will be sent out; you
will hear tones as they are sent. If you hear a
busy signal, go to Step 8 for hang-up
procedure.
5551135
6a Press , or /, to enter the telephone
list. / takes you forward to the next
member of the list; , takes you
backwards to the previous member of the list.
6b Stop at the member you wish to call.
6c The display alternates
between showing the
member’s name and
telephone number.
Alternates between
and
6d Press the PTT button.
6e The telephone number
will be sent out; you will
hear tones as they are
sent.
6f If you hear a busy signal, go to Step 8 for
hang-up procedure.
POLICE DEPT
5556445
POLICE DEPT
20L01-A_PR_UG_MTX4500.book Page 43 Friday, April 13, 2007 2:47 PM
To Next Page
Loading...
