Motorola Netopia 2200 - Page 189

189
set security ipsec tunnels name "123" encrypt-protocol { ESP | none }
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" auth-protocol {AH | ESP | none}
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode pre-shared-key-type
[ ascii | hex ]
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode pre-shared-key hex_string
See page 193 for details about SafeHarbour IPsec tunnel capability.
Example: 0x1234
set security ipsec tunnels name "123" IKE-mode
neg-method { main | aggressive }
See page 193 for details about SafeHarbour IPsec tunnel capability.
Note: Aggressive Mode is a little faster, but it does not provide identity protection for negotiations
nodes.
set security ipsec tunnels name "123" IKE-mode DH-group { 1 | 2 | 5 }
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode
isakmp-SA-encrypt { DES | 3DES }
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode ipsec-mtu mtu_value
The Maximum Transmission Unit is a link layer restriction on the maximum number of bytes of data in a
single transmission. The maximum allowable value (also the default) is 1500, and the minimum is 100.
set security ipsec tunnels name "123" IKE-mode isakmp-SA-hash
{ MD5 | SHA1 }
See page 193 for details about SafeHarbour IPsec tunnel capability.
set security ipsec tunnels name "123" IKE-mode PFS-enable { off | on }
See page 193 for details about SafeHarbour IPsec tunnel capability.