Hardware Setup
17
4.5 RFS6000 Series RF Switch Console Port Setup
To add the RFS6000 Series RF Switch to the network and prepare it for initial configuration:
1. Using the supplied console cable (pictured below), connect the RFS6000 Series RF Switch serial
port to an RS-232 (DB-9) serial port on a separate computer (the “configuration computer”).
2. On the configuration computer, configure a terminal emulation application
(such as HyperTerminal) as follows:
Terminal Type VT-100
Port COM port
Terminal Settings
19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression
To Next Page
Loading...
