Motorola RMV2080 User Manual

PROGRAMMING
FEATURES
English
39
Entering Programming Mode
Note: Before programming the features, make
sure your radio is set to the channel you
wish to program. You can do so before
entering Programming Mode or at any time
during the Programming Mode by turning
the Channel Selector Knob to the desired
channel
To read or modify Frequencies, Codes,
Auto-Scan and active Channels, set the radio
to 'Programming Mode' by long pressing both
the PTT and the SB1 button simultaneously
while turning ON the radio for 3 to 5 seconds
until a ‘chirp’ sounds to indicate that you have
entered 'Idle'Programming Mode (*).The LED
Indicator will start blinking a green heartbeat.
Note: (*)'Idle' Programming Mode is the stage of
the Programming Mode in which the radio is
waiting for the user to start the radio
programming cycle (refer “Entering
Programming Mode” on page 37)
Once you are in the 'Idle' Programming Mode,
you will be able to read the Frequencies,
Codes and Auto-Scan setting by short pressing
the PTT button to move along the different
programmable features.
Entering Frequencies Values
RM Series radios have 89 frequencies for UHF.
Once in ‘Idle’ Programming Mode, the first
value available to chage is Channel number,
you can go channel up or Channel down using
SB1 and SB2, after modified you will hear a
channel number confirmation. Pressing short
PTT you can select other features to be
confirmed or modified, again using SB1 and
SB2 you can change values. The radio always
via voice will signal the new value.

Motorola RMV2080 Specifications

General

Brand	Motorola
Model	RMV2080
Category	Two-Way Radio
Language	English