PROGRAMMING
FEATURES
English
42
•
If you ‘roll-over’ to the beginning at Idle
Programming Mode you will hear "Channel
number" and the LED Indicator will start blinking
green again. All values that were changed will be
automatically saved.
Programming Mode FAQ
1.
I got distracted while programming and
forgot which feature I was
programming. What should I do?
Return to 'Idle' Programming Mode and start
over, as you will not be able to return to the
Programming Mode (the radio does not provide
further way to let you know the specific stage
you are at when programming). Therefore you
can:
• Long press the PTT button. The radio will return
to the 'Idle' Programming Mode or,
• Turn OFF the radio and enter Programming
Mode again (see instructions in the beginning of
this section)
2.
I am trying to program a frequency (or
code) value but the radio would not do it.
It rolled over and took me back to value
‘0’.
The radio will not allow you to program any
values that are not available in the frequencies
and codes pool. For example, if you try to
program code 128, the radio would not accept
it, as the maximum value allowed is 122. Same
thing will happen with frequencies. Check the
Frequencies and Codes Charts section to make
sure you are programming a valid number.
3.
I am trying to enter the Programming
Mode but the radio would not do it.
The radio might be locked using the CPS to not
allow Front Panel Programming. To re-enable,
use the CPS.
To Next Page
Loading...
Need help?
General
