PROGRAMMING
FEATURES
English
44
•
Short press the PTT button to enter Frequency
Mode. Radio will announce current value
‘2’
• Press the SB1 button eleven times to increase
frequencies and you will be hearing ferquency
"13"
Long press the PTT button. LED Indicator will
show a green heartbeat to indicate 'Idle' state.
Long press the PTT button to exit Programming
Mode or turn radio OFF.
Example of Programming a Code
Assuming current code value is set to factory
default ‘001’, and you want to change it to
CTCSS/DPL Code = 103 follow the sequence
below:
• Enter Programming Mode
•
Short press the PTT button twice and you will
hear "Code Number" (Entering CTCSS/DPL
Programming Selection Mode).
•
Press and hold SB1 or SB2 buttons, shall fast
forward/rewind starting at the nearest 10's,
when released the radio starts playing the first,
second and third digit in full, keep pressing SB1/
SB2 several times until you hear "103"
Long press the PTT button. LED Indicator will
show a green heartbeat to indicate 'Idle' state.
Long press the PTT button to exit Programming
Mode or turn radio OFF.
•
•
•
•
To Next Page
Loading...
