xx
SPECTRA RADIO SERVICE AIDS (cont.)
Cables 3 and 4 allow connection to:
• VCO injection output to power amplifier for testing TX injection level.
• receiver front end/mixer input for testing receiver and/or front end mixer while bypassing
the antenna switch.
• receiver front end/mixer output for testing the proper mixer conversion gain
(use with HRF6002A and HRF6002B RXFE/Mixer Kits only)
• synthesizer feedback input for testing feedback buffer and prescaler operation
(use with HLF6002A and HLF6073A VCO Carrier Kits only).
• RF board IF input for testing receiver back end sensitivity.
• RX injection output of the VCO assembly.
5. 30-8037B27 BNC male to SMB female cable for mating to cable mounted SMB male connectors.
6. 01-80355A28 BNC female to Taiko-Denki female adapter for mating to cable-mounted Taiko-Denki
male connectors.
Cables 5 and 6 allow connection to:
• power amplifier providing test input.
• receiver input cable for testing RX loss through harmonic filter and antenna switch.
• VCO synthesizer feedback level (use with HLF6002A and HLF6073A VCO Carrier
Kits only)
• receiver front end/mixer output for testing the proper mixer conversion gain.
To Next Page
Loading...
