What to do if I cannot see characters on Motorola VC70N0 display?
If you cannot see characters on the display of your Motorola Automobile Accessories device, first, ensure the device is powered on and not in suspend mode by pressing the Power switch on the Quick Access Panel and turning on the main power switch. Then, adjust the brightness of the screen. Finally, adjust the display settings in the Control Panel.
How to fix Motorola VC70N0 touchscreen not working?
If the touchscreen on your Motorola Automobile Accessories device isn't working, recalibrate the screen using the Control Panel Calibration utility. Also, ensure that the screen protector is correctly applied or replace it if necessary.
What to do if Motorola VC70N0 Automobile Accessories vehicle computer does not power on?
If your Motorola Automobile Accessories vehicle computer does not power on, check the following: Ensure the power cable ignition sense wire (yellow) is properly connected. Verify that the main power switch on the right side of the vehicle computer is in the On position. Connect the power cable to the underside of the vehicle computer. If powered by a vehicle battery, replace or charge the battery.
What to do if the optional scanner does not operate with Motorola VC70N0 Automobile Accessories?
If the optional scanner is not operating with your Motorola Automobile Accessories VC70, check the following: * Ensure the scanner is properly connected to the COM1 port and that the vehicle computer is powered on. * Verify the external power connection.
What to do if I cannot see characters on the Motorola VC70N0 VC70 display?
If you cannot see characters on the display of your Motorola Automobile Accessories VC70, consider the following: * The VC70 might not be powered on. Check that the main power switch on the top of the VC70 is in the on position and press the power button. * The screen brightness may be improperly adjusted. Adjust the brightness of the screen. * The VC70 could be in Suspend mode (indicated by the green power LED being off). Press the power button to wake up the VC70.
What to do if my Motorola VC70N0 Automobile Accessories VC70 does not power on?
If your Motorola Automobile Accessories VC70 doesn't power on, there are several possible causes: * The power cable ignition sense wire (yellow) may not be properly connected. Ensure the power cable is correctly connected. * The main power switch on the right side of the vehicle computer might be off. Turn the main power switch to the on position. * The power cable may not be connected or might be unplugged. Connect the power cable to the power cable port on the bottom of the vehicle computer and press the power button. * If the VC70 is powered by a vehicle battery, the battery could be depleted. Replace or charge the vehicle battery.
Why is there no sound from my Motorola VC70N0?
If you are not hearing any sound when you tap the touchscreen or press a key on your Motorola Automobile Accessories, first, check the volume in the Control Panel and adjust it if necessary. Also, check if the application you are using has disabled the sound and configure the application to enable the sound. Ensure the external speaker is connected properly, or disconnect the cable if no external speaker is used.
What to do if the touchscreen is not working on Motorola Automobile Electronics?
General| Model | VC70N0 |
|---|---|
| Wireless LAN | 802.11a/b/g |
| Bluetooth | Bluetooth v2.1 with EDR |
| GPS | Integrated GPS |
| Audio | Integrated microphone and speaker |
| Expansion Slot | SD slot |
| Operating Temperature | -10°C to 50°C (14°F to 122°F) |
| Storage Temperature | -40°F to 158°F / -40°C to 70°C |
To Next Page
