49
connections
1
Place your phone near the device, and send the
file from the device.
If your phone and the sending device don’t
recognize each other, place your phone in
discoverable mode so the sending device can
locate it. Press
s
>
Connection > Bluetooth Link
> Find Me.
2
Press
Accept
key on your phone to accept the file
from the other device.
Your phone notifies you when file transfer is complete.
If necessary, press
Save
to store the file.
TTY operation
You can use an optional TTY device with your
phone to send and receive calls. You must plug the
TTY device into the phone’s headphone jack and set
the phone to operate in one of three TTY modes.
Note:
Use a TSB-121 compliant cable (provided by the
TTY device manufacturer) to connect the TTY device
to the phone.
Note:
Set the phone volume to level 4 (middle setting)
for proper operation. If you experience a high number
of incorrect characters, adjust the volume as needed
to minimize errors.
Note:
For optimal performance, your phone should be
at least 12 inches (30 centimeters) from the TTY
device. Placing the phone too close to the device may
cause high error rates.
set TTY mode
When you set your phone to a TTY mode, it operates
in that mode whenever the TTY devices is connected:
Find it:
s
>
Z
Settings
>
Initial Setup
1
Scroll to
TTY Setup
and press
Change
.
2
Scroll to one of the following
TTY Setup
options and
press
Select
.
option
Voice
Set to standard voice mode.
TTY
Transmit and receive TTY
characters.
Balina_W377.fm Page 49 Tuesday, July 24, 2007 5:43 PM
To Next Page
Loading...
