EN - 11
4.11).
WARNING! The pedal has to be re-
leased gradually, as a sudden engage-
ment may cause the vehicle to tip over
and the driver to lose control.
the throttle and gear lever. To change gear,
Hydrostatic transmission:
Press the drive pedal (see 4.22) in direction
-
WARNING! Drive must be engaged
as described below (see 4.22) to prevent
sudden engagement from causing tipping
up and loss of control of the vehicle, par-
ticularly on slopes.
5.4.3 Braking
Mechanical transmission
-
ing the accelerator so as not to overload the
Hydrostatic transmission
-
-
chine until it stops.
-
5.4.4 Reverse
IMPORTANT Reverse must only be engaged
when the machine has stopped.
IMPORTANT To proceed in reverse gear with
the cutting means engaged, it is necessary to
press and hold the consent pedal down (see 4.7)
so as not to cause the engine to stop.
Mechanical transmission
Hydrostatic transmission:
-
in the «R» direction (see 4.22).
5.4.5 Grass cutting
-
est position;
IMPORTANT If the cutting means are
engaged when the grass is too high, the
engine could suffer a sudden drop of r.p.m.
and stop in some cases, or the clutch may be
worn.
described;
– regulate the cutting height and speed (see
grass).
Mechanical transmission
1st gear
NOTE The fourth gear is just a transfer
gear to be used on the flat.
Hydrostatic transmission
pedal ac-
WARNING! When cutting on sloping
ground, the forward speed must be re-
To Next Page
Loading...
Need help?
General
