EN - 12
duced to ensure safe conditions (see 1A-
C7-8-9).
5.4.6 Emptying the grass catcher
(Fig. 5.10)
NOTE The emptying of the grass catcher can
only be done with the cutting means disengaged,
otherwise the engine stops.
channel.
– shift into neutral (N) (see 4.12 – Mechanical
-
– hold onto the rear handle (1) and tip up the
5.4.7 Unblocking the collector channel
-
-
WARNING! This job must only be per-
formed with the engine turned off.
5.4.8 End of mowing
-
5.4.9 End of work
When the engine has stopped, close the fuel
WARNING! To avoid backfire, put the
accelerator in the «SLOW» position for 20
seconds before stopping the engine.
IMPORTANT To keep the battery charged,
do not leave the ignition key in the «ON» position
when the engine is not running.
5.4.10 Cleaning the machine
electronic circuit board located under the seat.
IMPORTANT Never use hose-nozzles or
harsh detergents for cleaning the body and en-
gine!
WARNING! Do not let debris and dried
grass accumulate in the upper part of the
cutting-means assembly in order to maintain
maximum machine efficiency and safety
levels.
-
or debris.
WARNING! Wear eye protection and
keep people or animals away from the sur-
rounding area when cleaning the cutting-
means assembly.
a)
-
5.3.4);
– sit in the operator’s position;
-
To Next Page
Loading...
Need help?
General
