Why is the oil milky in my Mouvex HYDRIVE 2010A?
If the oil in your Mouvex Accessories appears milky, it could be due to insufficient oil reaching the pump, air entering the system, or water contamination. Refer to sections on 'Cavitation' and 'Air Entering the System'. Ensure all hose connections are secure, and inspect the suction pipe for any splits, replacing it if necessary.
What to do if there is high oil temperature in Mouvex HYDRIVE 2010A Accessories?
If you're experiencing high or excessive oil temperature in your Mouvex Accessories, first check the fan speed and adjust it if needed. Then, clean the radiator. Also, check 'Relief valve problems' and clean the cold start bypass.
Why is the motor not turning at the correct speed in my Mouvex Accessories?
If your Mouvex Accessories motor isn't turning at the correct speed, it might be due to a relief valve issue, damage to the pump or motor, a seized or blocked driven unit, or a system design problem. Inspect 'Relief valve problems', overhaul the unit, consult the driven unit's manual, and re-check the hydraulic calculations.
What causes high return pressure in Mouvex HYDRIVE 2010A Accessories?
If the return pressure in your Mouvex Accessories is too high, it could be due to a return line that's too small or long, excessive flow, a blocked return, or improperly installed quick release couplings. Consider increasing the pipe size, repositioning the Hydrive, reducing the speed of the driven unit, replacing the return filter, and ensuring the couplings are properly installed.
How to stop air from entering the system of Mouvex HYDRIVE 2010A?
If air is entering the system of your Mouvex Accessories, it may be caused by a low oil level in the tank or leaks in the suction hose or fittings. Refill the reservoir and re-prime the system. Tighten all hose connections and inspect the suction pipe for splits, replacing it if necessary.
What to do for relief valve problems in Mouvex HYDRIVE 2010A Accessories?
If the relief valve in your Mouvex Accessories is experiencing problems, such as continuously opening or sticking, try resetting the valve 10% above the circuit pressure or replace it with a new relief valve.
What causes high circuit pressure in Mouvex HYDRIVE 2010A?
If you notice excessive circuit pressure in your Mouvex Accessories, it might be due to an incorrect hydraulic pump selection or the driven unit requiring higher torque. Re-check the hydraulic calculations and inspect the driven unit for any seizure or blocked lines.
What causes cavitation in Mouvex HYDRIVE 2010A Accessories?
Cavitation in your Mouvex Accessories can be caused by a suction line that is too small or long, the pump being higher than the tank, too many restrictions or elbows in the suction line, or the pump speed being too high. Use a large bore pipe, move the Hydrive closer to the pump, re-position the Hydrive to ensure positive head pressure, re-route the pipe to minimize fittings, or reduce the pump speed.
Why are the motor seals leaking in my Mouvex HYDRIVE 2010A?
If the motor seals in your Mouvex Accessories are damaged or leaking, it could be due to worn seals, a disconnected drain line, excessive return line pressure, or high oil temperature. Repair or replace the seals. Install a case drain and replace the motor seals. Also, check 'Return line pressure too high' and 'Excessive oil temperature'.
Why is the pump leaking in my Mouvex HYDRIVE 2010A?
If your Mouvex Accessories pump is leaking, it could be due to worn seals or excessive circuit pressure. Repair or replace the seals and refer to the section on 'Excessive circuit pressure'.
General| Brand | Mouvex |
|---|---|
| Model | HYDRIVE 2010A |
| Category | Accessories |
| Language | English |
To Next Page