4.1 HYDRIVE pre-start up check list
1. Check the HYDRIVE reservoir to make sure it is full of
clean, uncontaminated oil, and that the level is no
lower than the red mark in the sight glass (6).
2. Check the radiator (44) for obstructions and dirt. Clean
as necessary.
3. Move the selector valve (if equipped) to the "OFF"
(Center or Neutral) position.
4.2 HYDRIVE operation
1. Set the tractor speed to idle RPM, depress the clutch
and engage the PTO. Release the clutch SLOWLY.
2. If equipped, SLOWLY set the selector valve on the
HYDRIVE from the "OFF" position to drive the requi-
red compressor or pump.
3. Set the tractor RPM to the required speed to obtain
desired system operation. DO NOT overspeed the
MOUVEX pump or compressor.
4. Inspect system for hydraulic oil leaks and for HYDRIVE
fan operation. If leaks or incorrect fan operation are
observed, shut down the system immediately. Repair
as necessary.
5. When system operation has been stabilized, check the
HYDRIVE operating temperature gauge, located on
the tank oil level sight glass. Maximum recommended
operating temperature for the HYDRIVE is 180°F
(82°C).
6. The operator should remain nearby the equipment through-
out the use to ensure the proper functioning of the system.
SET THE VEHICLE EMERGENCY BRAKE
AND CHOCK WHEELS BEFORE ATTEMP-
TING MAINTENANCE OR SERVICE.
WARNING
Hazardous machinery
can cause severe
personal injury
or property damage.
QUICK RELEASE COUPLINGS MUST BE
FULLY CONNECTED. FAILURE TO DO
SO CAN CAUSE PERSONAL INJURY OR
PROPERTY DAMAGE.
WARNING
Hazardous pressure
can cause
personal injury
or property damage.
12/16
NT 206-A00 10.11 Hydrive e
4. OPERATION
To Next Page
Loading...