3
EN
Safety Information
Batteries and
Charging
Laser Safety
Information
·
Do not use any third-party battery or base station with auto-empty. Use only
with RCED0102 supply unit.
·
Do not attempt to disassemble, repair, or modify the battery or the base
station with auto-empty on your own.
·
Do not place the base station with auto-empty near a heat source.
·
Do not use a wet cloth or wet hands to wipe or clean the charging contacts of
the base station with auto-empty.
·
Do not improperly dispose of old batteries. Unneeded batteries should be
discarded at an appropriate recycling facility.
·
If the power cord becomes damaged or broken, stop using it immediately and
contact after-sales service.
·
Make sure the robot is turned off when being transported and kept in its
original packaging if possible.
·
If the robot will not be used for an extended period, fully charge it, then turn
it off and store it in a cool, dry place. Recharge the robot at least once every 3
months to avoid over-discharging the battery.
·
The invisible laser sensor in this product meets the IEC 60825-1:2014, EN
60825-1:2014+A11:2021, EN 50689:2021 Standard for Class 1 laser products.
Please avoid direct eye contact with it during use.
CLASS 1 LASER PRODUCT
CONSUMER LASER PRODUCT
EN 50689:2021
Max output: <0.39mW
Wavelength: 840-860nm
Pulse duration: 0.125ms
Hereby, Dreame Trading (Tianjin) Co., Ltd. declares that the radio equipment type RLE22GDis in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address: www.mova-tech.com
For detailed e-manual, please go to https://www.mova-tech.com/pages/user-manuals-and-faqs
To Next Page
Loading...
