15
EN
Routine Maintenance
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
Part Maintenance Frequency Replacement Period
Mop pad After each use
Every 3 to 6 months
Filter Once every week
Main brush
Once every month
Every 6 to 12 months
Side brush Every 3 to 6 months
Robot's charging contacts
/
Robot's auto-empty vent
Laser Distance Sensor (LDS)
Return-to-Dock Sensors
Bumper
Omnidirectional wheel
Cli sensors
Bottom of the robot
Base station's signaling area
Base station's charging contacts
Base station's auto-empty vent
Water tank
Clean it as needed
Dust box
Dust bag
/ Every 2 to 4 months
Note: The replacement frequency will depend on your usage of the robot. If an exception occurs due to special circumstances, the parts should be replaced.
To Next Page
Loading...
