Mova E20 Plus - How to Use

12
EN
How to Use
Turn On/O
Press and hold the button for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base station, the
robot should turn on automatically and begin charging. To turn o the robot,
move the robot away from the base station and press and hold the button
for 5 seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Start Cleaning
Press the button to start cleaning after the robot is turned on. The robot
will accurately map out a route, methodically clean along the edges and
walls, then finish by cleaning each room in an S-shaped pattern to ensure a
thorough job.
Note:
· It is recommended that the robot set out from the base station before
cleaning. Do not move the base station while the robot is cleaning. This
ensures that the robot returns to base station smoothly.
· After the robot completes the cleaning task and automatically returns to the
base station, the base station will start auto-empty. More settings can be
operated on the app.
Pause
When the robot is running, press any button to pause it.
Note: If the robot is paused and placed onto the base station, the current
cleaning task will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the base station
to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please enable it in the app.
Do Not Disturb (DND) Mode
When the robot is set to Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator will turn o.
DND mode is disabled by default at the factory. You can use the app to enable
DND mode or modify the DND period. The DND period is 22:00-8:00 by
default.
Note:

·

The scheduled cleaning tasks will be performed as usual during the DND
period.
· The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press and hold the button for 3 seconds
to enable the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5×1.5 meters around it and returns to charge once the spot
cleaning is completed.
Robot Restarting
If the robot stops responding or cannot be turned o, press and hold the
button for 15 seconds to forcefully turn it o. Then, press and hold the
button for 3 seconds to turn the robot on.