16
EN
Routine Maintenance
Main Brush
1. Press the brush guard clips upwards to remove the brush guard and lift the
brush out of the robot.
2. Use a proper tool to remove any hair tangled in the brush.
Note: Do not pull out the hair tangled in the main brush excessively.
Otherwise, the brush may be damaged.
Side Brush
Pull out the side brush and use a proper tool to remove any hair tangled in the
brush.
Omnidirectional Wheel
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
To Next Page
Loading...
