10
EN
Note:
· Do not place the base station on the carpets.
· Make sure that no objects might block the signaling area.
· Remove any objects that are closer than 1.5 m from the front and 0.5 m
from either side of the base station.
Place the base station in a location that is as open as possible with a
good Wi-Fi signal.
Place the base station on level ground against the wall and plug the power
cord into the socket.
When placing the robot, align the charging contacts of the robot with the
charging contacts of the base station, and the robot will automatically turn
on and start charging.
> 0.5 m
> 1.5 m
> 0.5 m
Note: Install the side brush until it clicks into place.
Click
1. Remove the protections
Before Use
Note: It is recommended to fully charge your robot before first time use.
3. Place the base station and connect to an electrical outlet
4. Charge the robot
2. Install the side brush and the mop assembly
To Next Page
Loading...
