13
MOVADO BOLD MOTION USER GUIDE
RESETTING YOUR WATCH TO FACTORY SETTINGS
NOTE: Resetting the watch to factory settings removes all
user data from the watch. Reset the watch only if you are
experiencing a serious problem that has not been solved
after trying all other troubleshooting methods, or if you
want to pair the watch with a different phone. Use one
of the following methods:
If your watch is connected to your phone, use the phone
app to reset your watch.
1. In the app, select PREFERENCES.
2. Tap FORGET WATCH.
3. In the confirmation dialog, tap PROCEED.
If your watch is not connected to your phone, use the
watch button to reset your watch.
Press and hold the watch button. After all lights cycle
clockwise once, release the button.
Then, all lights cycle counterclockwise. During the six
seconds the lights cycle counterclockwise, you can
press the button to cancel the reset. After the lights cycle
counterclockwise, all lights pulse, and then the watch
resets.
CARE AND MAINTENANCE
Charging and replacing the watch batteries
The watch contains two batteries. One battery controls
the digital functions of the watch and can be recharged.
The other battery controls the analog functions of the
watch and is not rechargeable. Under normal use, the
battery that controls the analog functions of the watch
should last approximately two years.
Never open the watch yourself. If your watch needs
repair or adjustment, take or mail it directly to a Movado
Authorized Service Center. Do not attempt to change
the batteries yourself. If one or both of your batteries
needs to be changed, take or send your watch to a
Movado Authorized Service Center to have battery(ies)
changed. To locate a service center in your region, visit
http://www.mgiservice.com/movado and click FIND
AN AUTHORIZED WATCH REPAIR LOCATION.
NOTE: The Movado Watch Company assumes
responsibility only for service performed at its Authorized
Service Centers.
Cleaning the connection pins of the watch and charger
Each time you need to charge your watch, disconnect
the charger from power and thoroughly wipe the charger
and watch contact pins with a soft, lint-free cloth before
connecting the charger to power and then to the watch.
If necessary, you may dampen the cloth with a small
amount of isopropyl rubbing alcohol. Never use soap
or any chemicals other than isopropyl rubbing alcohol to
clean the contact pins for the watch or charger.
Caring for your watch strap
While the life span of a watch strap depends on your
care and wearing habits, as well as the climate in which
you live, proper care will extend its life.
To help preserve the natural elasticity and quality of your
watch strap, wipe the strap with a soft cloth soaked in
fresh water or a dilute detergent if the strap has been
exposed to salt water, chemicals, isopropyl alcohol, or
abrasive substances. Contact with acetone, ethyl alcohol,
organic solvents, and perfume should be avoided.
NOTE: Movado watch straps are not covered by the
Movado watch warranty.
Water resistance
All Movado watches are tested to meet international
standards for water resistance. This style is resistant
to 50 meters (5 ATM), as marked on the case back;
however, because of its connectivity feature, Movado
recommends not wearing your Movado BOLD Motion
watch when showering or swimming. You should avoid
submerging the watch in water or allowing the contact
pins to get wet. Moisture and electrolyte residues (salts
and chlorides) can cause corrosion and possibly short
circuit the contact pins.
If the contact pins get wet, wipe them with isopropyl
alcohol, and then dry them with a soft cloth. The contact
pins must be moisture-free before you attach the charging
cable.
CAUTION: Do not subject your watch to a pressure/
depth greater than 50 meters (5 ATM), or your watch
could be damaged and your warranty voided.
IMPORTANT: Do not operate the watch button or pull the
crown out while the watch is wet or underwater.
To Next Page
Loading...
