Movincool Classic Plus 26 - View and Delete Programs; Run and Stop Programs

23
OPERATION (cont.)
How to View and Delete Program
1. Press and hold the SET PROG button for 3 sec until beep.
2. To view edited program - While pressing and holding the SET PROG button,
press SET TEMP buttons ( / ) to scroll the program sequence.
3. To delete a program - Press ENTER and SET PROG buttons once
simultaneously.
4. To delete multiple program - Press and hold ENTER and SET PROG buttons
simultaneously.
How to Run and Stop Program
1. Press RUN/STOP button to activate preset program (LCD indicates
“PROGRAM ON”). During PROGRAM RUN mode, if you RESET (see
page 25), PROGRAM RUN mode is terminated. To resume PROGRAM RUN
mode, you must press RUN/STOP button again.
2. Press RUN/STOP button to stop program.
Note:
1. The unit returns to the previous mode if a program is turned off while it is
running.
2. The LCD continues to indicate “PROGRAM ON” during program activating.
3. Program can be set during power on standby, during unit running, or during
program running.
4. During programming, the unit returns to the previous mode if no activity occurs
within approximately 3 min.