- 8 -
Be sure to disconnect the power cord before installing and/or
wiring your
EDR-8010 Series.
Calculate the maximum possible current in each power wire
and common wire. Observe all electrical codes dictating the
maximum current allowable for each
wire size.
If the current goes above the maximum ratings, the wiring
could overheat, causing serious damage to your equipment.
Please read and follow these guidelines:
• Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
NOTE: Do not run signal or communications wiring and power
wiring through the same wire conduit. To avoid interference, wires
with different signal characteristics should be routed separately.
• You can use the type of signal transmitted through a wire to
determine which wires should be kept separate. The rule of thumb
is that wiring sharing similar electrical characteristics can be
bundled together.
• You should separate input wiring from output wiring.
• We advise that you label the wiring to all devices in the system.
• This product is intended for installation in Restricted Access
Location.
Hot Surface. Do not touch.
The SFP module only supports Laser Class 1 optical
transceivers.
Grounding the EDR-8010 Series
Grounding and wire routing help limit the effects of noise due to
electromagnetic interference (EMI). Run the ground connection from
the ground screw (M4 type) to the grounding surface prior to
connecting devices.
This product is intended to be mounted to a well
-grounded
mounting surface such as a metal panel.
Use the green-and-
yellow cable type AWG (American Wire Gauge) min.18 (0.75
mm2) for grounding.
To Next Page
Loading...
