MGate MB3000 Modbus Gateway User Manual
The dialog boxes will guide you through the process. You will need to browse your PC for the firmware file.
Make sure that it matches your model.
As the firmware is written to the unit, progress is displayed in the window.
ATTENTION
DO NOT turn off the MGate’s power before the firmware upgrade process is completed. The MGate will be
erasing the old firmware to make room for the new firmware to flash memory. If you power off the MGate
and terminate the progress, the flash memory will contain corrupted firmware and the MGate will fail to
boot. If this happens, call Moxa RMA services.
Once the firmware has been successfully written onto the unit where the status is shown as OK, then click
Exit to close the Upgrade Firmware window. MGate Manager will automatically execute a Broadcast Search
for all MGate MB3000 units on the LAN. Your MGate should reappear in the list of units.
ATTENTION
While executing firmware upgrade, it is recommended to back up the configuration file by using Export
function. Once the latest firmware is successfully written onto the unit, it is recommended to reset the
device to default by using Load Default function.
To Next Page
Loading...
Need help?
General
