MPI EchoTable 051/251 - Hand Control Functions; Adjusting Surface Height; Adjusting Fowler; Adjusting Trendelenburg

Use Instructions
EchoTable User Manual Page 16 of 45 DCR-00576
(MAN-0011-D)
Hand Control Functions
Hand control functions will vary depending on the model purchased. Your hand control
may not include all of the functions listed below.
Adjusting Surface Height
The surface height may be adjusted between 24” and 34”.
Press and hold the applicable hand control
function to adjust the seat height.
Adjusting Fowler
The Fowler section may be adjusted between 0° and 65°.
Press and hold the applicable hand control
function to independently adjust the
Fowler.
Adjusting Trendelenburg
The table may be adjusted between 15° Trendelenburg and 15° Reverse Trendelenburg.
Press and hold the applicable hand control
function to independently adjust the
Trendelenburg angle.