EchoTable User Manual Page 8 of 45 DCR-00576
(MAN-0011-D)
Set Up
The product has been shipped in “plug and play” condition. After unpacking the
product, an initial test should be performed to ensure that each function is in correct
working order. After performing the test and reviewing this manual the product is ready
for use.
1
After removing padding and packaging materials locate primary power
supply cord and attach to suitable grounded power outlet.
2
To test actuator function, locate the hand control
button one at a time. (Depressing multiple buttons simultaneously will
prevent the actuators from operating.)
3
If any function does not operate, perform the test procedures listed in the
Troubleshooting Guide.
Transport Position
It is recommended that the patient surfaces be in a horizontal position if the product is
used to transport patients.
To Next Page
Loading...