EchoTable User Manual Page 33 of 45 DCR-00576
(MAN-0011-D)
Troubleshooting Guide
No Actuator Function
Actuator(s) Not Running.
• Power cord not plugged all
the way into wall
receptacle.
• Push power cord securely
into receptacle.
• Power outlet receptacle not
supplying 120 VAC power.
• Check power availability or
plug unit into another
receptacle.
• The power cord may be
separated from the control
box.
• Securely press power cord
into control box.
• Battery may be drained. • Replace or charge battery.
• Actuator cord may be
unplugged.
• Push actuator cords
securely into actuator
receptacle.
• Product was overloaded
and tripped internal fuse in
control box.
• Replace control box.
• Product motion is limited at
certain heights and angles.
• Return the surface to a level
position to restore full
range of motion
• The product will not move
when hand control buttons
are pressed.
• The hand control buttons
may be locked. If the green
LED on the hand control is
lit then press the unlock
button for 3 seconds to
unlock the hand control
functions.
Squeaking noises during
operation.
• Actuator pins are not
sufficiently lubricated
• Apply WD40 or similar
lubricant to actuator pins.
WARNING
Do not modify this equipment without authorization of the manufacturer.
• Removal of secured covers may increase the risk of electrical shock. Refer servicing to
qualified personnel.
• The battery should be periodically inspected for damage. Replace the battery if necessary.
To Next Page
Loading...