MPI EchoTable 051/251 - Memory Function; Hand Control Lock;Unlock

Use Instructions
EchoTable User Manual Page 17 of 45 DCR-00576
(MAN-0011-D)
Memory Function
Some product configurations have the ability for the user to set memory positions. The
control box can store two unique positions for buttons P1 and P2. The memory feature
stores the position for height, Fowler, and trend.
Set the table to the desired position.
To set a memory position, press and hold
the “M” button and then simultaneously
press and hold either “P1” or “P2”. The
green LED at the top of the hand control
will flash 3 times when the memory
position has been set. Setting a memory
function takes approximately 3-4 seconds.
The memory positions can be reset to new
positions by following the instructions
above.
Hand Control Lock/Unlock
The hand control function may be locked during the procedure to prevent unwanted
movement if the buttons are inadvertently depressed.
Press and hold the lock/unlock button for 3
seconds to lock functions. The green LED at
the top of the hand control will light up.
Press and hold the lock/unlock button for 3
seconds to unlock functions. The green LED
at the top of the hand control will turn off.