27
GB
3
The bread loaf is stuck in the
bread pan.
The kneading paddle is stuck on
the shaft.
Thoroughly clean the kneading paddle and
the bread pan after each use; pour boiling
water into the bread pan to release the
kneading paddle if stuck.
4
The ingredients are not blended
well or the bread is not well done.
1. Wrong program set.
Use a correct program.
2. There was a power outage which
exceeded 20 minutes.
Empty the bread pan and add fresh
ingredients again. Restart the process.
3. The bread maker lid was opened
not completely shut during
processing.
Always check that the lid is tightly closed.
Keep the lid closed during processing.
4. The kneading paddle was stuck or
not connected well to the shaft.
Install the kneading paddle securely.
5
The bread maker does not start
processing. "HHH" is displayed.
The bread maker is still too hot to
start a new process.
Wait for the bread maker to cool down.
Open the lid to cool it down faster.
6
The bread maker makes sounds as if
it was working while it is not.
The bread pan and/or the kneading
paddle are not properly installed.
Too much ingredients in the bread
pan.
Verify proper installation of the bread pan /
kneading paddle. Put the correct amount of
ingredients in the bread pan.
7
The dough rises out of the bread
pan.
Too much flour or yeast. Wrong
program set.
Check the amount of ingredients.
Use a correct program.
8
The dough does not rise.
The ingredients are not correct
or have expired. The water is too
warm.
Use good and fresh ingredients. The water
should be at ambient temperature.
9
Once it has risen, the dough sinks
in the centre.
1. Gluten-free flour was added.
Use a gluten flour.
2. Too much water.
Check the water dosage.
10 The finished bread texture is thick.
1. Too much flour and/or too little
water.
Check the water and flour dosage.
2. The fruit dose is too big.
Add less fruits.
TECHNICAL SPECIFICATIONS:
See the product’s nameplate for technical specifications.
Power cord length: 0.82 m
PROPER DISPOSAL OF THE PRODUCT (waste electrical and electronic equipment)
This symbol on the product indicates that the product, after its lifetime, should not be disposed with other
household wastes. To avoid harmful influence on the environment and human health due to uncontrolled
waste disposal, dispose the waste device to the service point of waste household appliances or report
collecting it from home. In order to obtain detailed information about the location and how to dispose
the waste electrical and electronic equipment in a safe way, contact your retailer or local Department
of Environmental Protection. Do not dispose the device with other municipal waste.
Poland
To Next Page
Loading...