To configure charger
source priority
If this inverter/charger is working in Line, Standby or Fault
mode, charger source can be programmed as below:
Solar energy will charge battery as
first priority.
Utility will charge battery only when
solar energy is not available.
Utility will charge battery as first
priority.
Solar energy will charge battery
only when utility power is not
available.
Solar and Utility
(default)
Solar energy and utility will charge
battery at the same time.
Solar energy will be the only
charger source no matter utility is
available or not.
If this inverter/charger is working in Battery mode or Power
saving mode, only solar energy can charge battery. Solar
energy will charge battery if it's available and sufficient.
Auto return to default
display screen
Return to default
display screen
(default)
If selected, no matter how users
switch display screen, it will
automatically return to default
display screen (Input voltage
/output voltage) after no button is
pressed for 1 minute.
If selected, the display screen will
stay at latest screen user finally
switches.
Beeps while primary source
is interrupted
To Next Page
Loading...
Need help?
General