61
4. LCD Display Information
Press “UP” or “DOWN” key to switch LCD display information. It will show battery pack and battery group
number before “Main CPU version checking” as below screen.
Battery pack numbers & Battery
group numbers
Battery pack numbers = 3, battery group numbers = 1
5. Code Reference
Related information code will be displayed on LCD screen. Please check inverter LCD screen for the operation.
If battery status is not allowed to charge and
discharge after the communication between the
inverter and battery is successful, it will show
code 60 to stop charging and discharging
battery.
Communication lost (only available when the
battery type is setting as “Pylontech Battery”.)
After battery is connected, communication
signal is not detected for 3 minutes, buzzer
will beep. After 10 minutes, inverter will
stop charging and discharging to lithium
battery.
Communication lost occurs after the
inverter and battery is connected
successfully, buzzer beeps immediately.
If battery status is not allowed to charge after
the communication between the inverter and
battery is successful, it will show code 69 to
stop charging battery.
If battery status must to charge after the
communication between the inverter and
battery is successful, it will show code 70 to
charge battery.
If battery status is not allowed to discharge
after the communication between the inverter
and battery is successful, it will show code 71
to stop discharging battery.
To Next Page
Loading...
Need help?
General