MRC INE-PHS-3E - Operating Flow Diagram

INE-PHS-3E 2016
5
INE-PHS-3E
Operating flow diagram
Switch on the meter
Enter manual or auto. temp. measurement selection
mV measurement
Press “pH/mV” button
pH measurement
Press “Std” button
Enter calibration state
Press “Slope” button
Enter slope adjusting state
Press “pH/mV” button
If the temperature electrode is not
connected to the meter, enter manual
adjusting temp. state. Press “Ÿ” or
“ź” button to adjust temp. larger or
smaller manually, and then press
“ENTER” button to confirm the temp.
selected.
Enter
(auto. Calibration
adjusting)
Press “Ÿ” or “ź” button
to adjust calibration value
manually
Enter
(auto. slope
adjusting)
Press “Ÿ” or “ź” button to
adjust slope calibration
value manually