MS ENERGY e21 - Battery Removal and Installation; Install the Battery

ENG
14
BatteryRemovalandInstallation
1.Unscrewthepedalcover
screwcounterclockwise.
2.Liftthepedalcoverfrom
thequick‐releasescrewon
therearwheelside.
3.Liftthebatterystrapand
takeoutthebattery.
4.Unplug the charging plug
andthepowerplugofthe
controller.
1.Putthebatteryvertically
intothescooter.
2.Connectthechargingplug
andthepowerplugofthe
controllertothebattery.
Attention:Allcontacts
mustfitwellandbefirm!
3.Coverthepedalandfasten
the silicone edge of the
pedal.
4.Install thescrews and
tightenitclockwise.
Install the battery