MS ENERGY e21 - LED Display; Instructions of Buttons

ENG
17
5. LEDDISPLAY
Instructionsofbuttons
1. PowerSwitch:
LongpressthePowerbuttontoturnon/offeScooter.
2. Function/Lightbutton:
A: ShortpresstheFunctionbuttononce:Cycletoswitchgears:
Pedestrianmode:Gearindicator isnotdisplayed.
Thepedestrianindicatorflashes.MAXSPEED6km/h
Normalmode:Gearindicator showsWhite.MAXSPEED15km/h
Sportsmode:Gearindicator showsRed.MAXSPEED25km/h
B: ShortpresstheFunctionkey2x:turnOn/Offthefrontandrearlights
Whenthefrontlightsareon,thetaillightsarealwayson
3. Accelerator:
Pressthrottletostartandaccelerate.
Note
:Ifnon‐zerostartisdefaultseting,thenthenyouhavetopushthescooterwith
yourfoottohaveaspeed≥3km/hforthethrottletobeactive.
4. Brake:
Holdthebrakehandletobrake.Ifnecessarylightlystepontherearfendertoassist
thebrakes.
5. Cruisemode:
Aftertheconstantspeedcruisefunctionisturnedon,maintainthecurrent
vehicle speed for 8 seconds (vehicle speed ≥ 6km/h) and the cruise mode
will activate automatically.Cruisemodeisdeactivatedwhenpressingthe
accelerationdialagain orholdingthebrakefirmly.
Note:Whenthebrakeisactive,pressingthethrottlebuttontoaccelerateisinvalid!
Multifunction
(
o
p
t
)

Gearindicator
S
p
eedunit
Faultdis
p
la
y

S
p
eed
Batter
y
level