To Next Page

To Previous Page

NOTE: Make sure the board to board connector is

properly aligned.

7. Install the four external screws with a Phillips head

#1 torque screwdriver. Torque to 6 in-lbs (0.68 N-m).

8. Calibrate the device per the instructions in the

ALTAIR io 4 User Guide.

5.1.7 Back Housing Replacement

This section will briefly describe how to replace the back housing on the ALTAIR io 4 Gas Detection Wearable.

Tools Required:

• Phillips head #1 torque screwdriver

• Torx T6 torque screwdriver

ALTAIR io 4 44

5 Device Care US

Other manuals for MSA ALTAIR io 4

Questions and Answers:

Need help?

Do you have a question about the MSA ALTAIR io 4 and is the answer not in the manual?

General