MSA Cairns 1010 - Models 1010 and 1044 (Grey Impact Cap), 660 C, 664, HP3, 880, 360 R, 360 R-13, and 360 S; Suspension; Ear Cover, Ratchet Cover, and Liner; Headband

MSA Cairns Fire Helmets16
US
5.3.2.2 Models 1010 and 1044 (Grey Impact Cap), 660C, 664, HP3, 880, 360R,
360R-13, and 360S
• Cracks
• Depressions or dents equal to or larger than a thumbnail
• Punctures, blisters, or discoloration due to impact, excessive heat, or normal wear
• Cracked and distorted (that is, out of round) plastic tube
• Rigid rubber tube (should be supple and elastic)
5.3.3 Suspension
If any of the following conditions exist, replace the suspension:
• Straps have missing, cut, fraying, or broken stitching
• Straps are torn or abraded
• Straps are brittle or discolored
• Suspension attachment clips are broken, brittle, whited, or discolored
5.3.4 Ear Cover, Ratchet Cover, and Liner
If any of the following conditions exist, replace the applicable part:
• Missing, cut, or broken stitching
• Torn, discolored charred, perforated or seared
• Missing hook-and-loop fasteners for ear cover (excluding MSA Cairns 880 Fire Helmets, which do
not have hook-and-loop fasteners)
5.3.5 Headband
If any of the following conditions exist, replace the headband:
• Brittle, torn, cracked, or broken
• Holes
• Able to open ratchet by tugging on nape arms (rather than turning the knob)
5.3.6 Chinstrap
If any of the following conditions exist, replace the chinstrap:
• Frayed, missing, or broken parts
• Missing, cut, frayed, or broken stitching
• Clogged or worn-out hook-and-loop fastener
• Brittle, broken, or missing quick-release button
• Loose Postman's Slide
• Broken or cracked attachment points
5.3.7 Goggles
If any of the following conditions exist, replace the goggles or mounting hardware, as applicable:
• Damage to the ventilation and/or filtration areas
• Damage to the lens, frame, straps, adjustment assembly, and/or mounting hardware
5.3.8 Faceshield and Hardware
If any of the following conditions exist, replace the faceshield or mounting hardware:
• Blistered, bubbled, cracked, charred or otherwise damaged hardware or lens
• Missing E-ring retainer on adjustment knob
5.3.9 NFPA-compliant Bourke Lenses
If any of the following conditions exist, replace the Bourke Lenses or mounting hardware:
• Blistered, bubbled, cracked, charred or otherwise damaged hardware or lenses