EasyManua.ls Logo

MSA EVOLUTION Receiver Station - 6 Maintenance; 7 Cleaning; 8 Technical Data; Transmitter (Transmitter On;In the Camera)

MSA EVOLUTION Receiver Station
83 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
GB
GB
6 Maintenance
General Maintenance
The following is to be checked after each use:
Visual check of all parts for mechanical, chemical or heat-
related damage.
Visual check of the components for loose and/or missing
screws, as well as loose and/or missing O-rings and/or
seals.
For accumulators see instructions for use of the camera /
video transmitter
Note:
Components that do not pass visual inspection must be taken
out of operation until the appropriate repairs have been carried
out. Repairs or changes that are outside the measures
described in these instructions or in the instructions for use of
the camera / video transmitter or that are carried out by anyone
other than a person authorised by MSA AUER will invalidate any
warranty claim. Use only original MSA AUER replacement parts.
7Cleaning
After each use all external surfaces are to be wiped with a solution
of a mild cleaning agent and warm water.
Then rub dry with a soft, dust- and lint-free cloth, during which
care is to be taken that optical components are not scratched.
Check connections, sockets, switches, locks and hinges for
fouling and if necessary clean with a soft, dust- and lint-free
cloth.
8Technical data
8.1 Transmitter (transmitter on/in the camera)
Adjustable frequency range: 2.3 - 2,5 GHz
Country-specific frequencies are pre-set. No setting of other
frequencies by the user is permitted.
Transmission power EIRP: 450 mW
8.2Base station
Case:
W x H x D 61,5 x 25 x 51,5 cm
Total weight in case 17.0 kg
case closed
IP 66
Power supply
Operation by mains voltage
Voltage range AC 100 - 240 V,
50 - 60 Hz
Power input approx. 30W
Operation via motor vehicle on-board electrical system
Voltage range DC 11.7V - 30V
Switch off for low voltage < 11.7V
Current input at 12V 1.8A
(with Clipmaker 2.2A)
Current input at 24V 1.1A
(with Clipmaker 1.3A)
Protection class II
Operating temperature 0°C to 50°C
Storage temperature -10°C to 60°C
Antenna and Receiver
Antenna Directional antenna 18 dB
Aperture angle 16°
Receiver IP 65
Adjustable frequency range: 2.3 - 2,5 GHz
Country-specific frequencies are pre-set. No setting of other
frequencies by the user is permitted.
Connecting cable 7 m cable with DIN-AV plug for
adapter box
Video output for external monitor
BNC-socket 1V ss / 75Ohm / Pal

Table of Contents

Related product manuals