45
3103-1001 Rev. 0
"System Menu" - An HMI navigation button which switches the screen back to the System Setup
Menu.
4.2.4 User Configured Output (UCO) Option
The User Configured Output (“UCO”) Option screen is used for one or both of the options available
in the MultiGard 5000 unit. A UCO option allows the user to custom configure outputs for special
uses. The user has full control over what points logically combine to trigger an output and any of the
special output features that are available. This screen specifically allows the operator to define all
output related features of one or both of the options. See Chapter 7 for complete details on how to
apply the UCO option(s). This screen also leads to the UCO Enable screen.
Figure 25: UCO Output
The UCO screen consists of the following:
"User Configured Output Option #1" - This is the screen title and also shows which option the other
information is related to. When switched, the title can also read "User Configured Output Option
#2".
"UCO#1 is Available" - This is an indicator that shows UCO option #1 has been MSA factory
configured. If UCO option #1 was not configured the indicator will read "UCO#1 is NOT
Available".
"Enter Output to Configure:" - This is a numerical entry element which allows the user to directly
To Next Page
Loading...
