The Test Bench should be installed on a at surface of the oor. The test bench construction does
not require mounting to the foundation. The test bench legs are equipped with height adjusters.
Inspect the device for existence of damage. If it is found, please contact either the manufacturer
or the trade representative.
It is strongly recommended not to hold onto the housing of the equipment when installing and
dislocating it. Make sure that the power uid is in the system. If necessary, ll up the test bench
hydraulic system to the required level through the drainage container of the tabletop.
Earth the test bench. Connect MS300 to 380 V electrical power supply.
Set the required working pressure value of the hydraulic system of the test bench in accordance
with the paragraph 6.2 of this manual (pressure set by the manufacturer is 140 bar).
WARNING! In case of obvious damage, use of equipment is forbidden.
3.3 Placement location
3.4 Preparation for use
5
User Manual - Test bench MSG MS300
English
To Next Page
Loading...
