A-7
Using 4- or 6-Channel Audio Function
1
2
3
Back Panel
6
7
4
5
4-Channel Mode for 4-Speaker Output
When this mode is selected, plug the two front speakers to the Line
Out connector on the back panel, and the other two rear speakers to
the Line Out connector on the S-Bracket.
Refer to the following diagram and caption for the function of each
phonejack on the back panel and S-Bracket when 4-Channel mode
is selected.
1 Line Out (Front channels)
2 Line In
3 MIC
4 Optical SPDIF jack
5 Coaxial SPDIF jack
6 Line Out (Reserved for Center
and Subwoofer channel, but it
is not functioning here)
7 Line Out (Rear channels)
Select “Default Phonejack” Deselect “Default Phonejack”
1 Line Out (Front channels)
2 Rear Speaker Out (Rear channels)
3 MIC
4 Optical SPDIF jack
5 Coaxial SPDIF jack
6 Line Out (Reserved for Center and
Subwoofer channel, but it is not
functioning here)
7 Line Out (Rear channels)
To Next Page
Loading...
Need help?
General
