3-23
BIOS Setup
Integrated Peripherals
Please note that the options showed on your BIOS might be different
depending on the motherboard you buy.
USB Controller
This setting is used to enable/disable the onboard USB controllers.
USB Device Legacy Support
Set to All Device if your need to use any USB 1.1/2.0 device in the operating
system that does not support or have any USB 1.1/2.0 driver installed, such as
DOS and SCO Unix. Set to No Mice only if your wan t to use any USB device
other than the USB mouse. Setting options: Disabled, No Mice, All Device.
On-Chip IDE
Press <Enter> to enter the sub-menu and the following screen appears:
To Next Page
Loading...
