Chapter 6
6-4
Q: How do I know if my VGA card is running under AGP 4x
mode? If not, how can I use AGP 4x mode?
First of all, make sure that your mainboard supports AGP 4x mode.
Refer to your mainboard documentation for relative information.
Secondly, check the BIOS setting for the AGP mode (if any, please
see your mainboard documentation).
Finally, install the proper driver for your VGA card. If the driver is
installed correctly, click the Start button , and then point to
Settings. Point to the folder that contains Control Panel. In Control
Panel, double-click Display to set the values. For example, when
you installed the dedicated driver for your MSI VGA card, which is on
the software CDs in your VGA card package, you will see the MSI
Information tab in the Display Properties window. Click 4x under
AGP Information to enable this function (see instructions in Chap-
ter 3 Software Installation).
Q:
My monitor display becomes abnormal after the system running
for minutes (blank screen, color blocks, flicking or overlapping
screen image).
Check the memory clock and core clock under Display Properties.
If the values are set too high (exceeding the recommended spec.),
please try the default values.
Keep your monitor away from magnetic objects, such as speakers
without antimagnetic design or mobile phones. The magnet and
electromagnetic wave will influence and damage your monitor.
If the problem happens continuously, please contact your local
dealer for further service.
To Next Page
Loading...
Need help?
General
